Handbook

The “Handbook of Test Procedures and Protocols” is a collection of test procedures and protocols that were gathered, or developed and used within the ENDURANCE project.

To download the entire handbook, click here.

To view its contents and download procedures/protocols one by one, take a look at the Table of contents.

CHAPTER 2: Testing Procedures from the Literature

SECTION 1: Projects

Thermal and current load testing results for Integrated Planar and short SOFC stacks – Birmingham experience within RealSOFC
Dr Waldemar Bujalski, University of Birmingham / REALSOFC - Project no. 502612, FP6-2002-ENERGY-1

Real-SOFC- A Joint European Effort to Improve SOFC Durability
Robert Steinberger-Wilckens Forschungszentrum Julich GmbH / REALSOFC – Project no. 502612, FP6-2002-ENERGY-1

Solid Oxide Fuel Cells (SOFC)
Dr Waldemar Bujalski, University of Birmingham / REALSOFC - Project no. 502612, FP6-2002-ENERGY-1

Definition of the ADEL testing protocol and revised test matrix
EIFER / ADEL - Project no. 256755, FP7-JTI

Testing method (DoE, initial test matrix and test protocol including required experimentation) incl. data analysis requirements
EIFER / DESIGN - Project no. 256693 FP7-JTI

Report on testing SCO tolerant ST cells towards P=0.4 W/cm2
TOFC / SCOTAS - Project no.: 256730, FP7-JTI

Application oriented functional / performance Test Program validation report including Test Program revision
Jens Mitzel (DLR) / STACKTEST - Project no.: 303445, FP7-JTI

International standard status report
Fabrice MICOUD, Sebastien ROSINI (CEA) / STACKTEST - Project no.: 303445, FP7-JTI

Application oriented safety / environmental test program validation report including test program report
Thomas Jungmann (Fraunhofer ISE), Jurgen Hunger (ZSW) / STACKTEST - Project no.: 303445, FP7-JTI

Application oriented durability test program validation report including test program release versions
Frederik Nygaard (DTU), Jurgen Hunger (ZSW) / STACKTEST - Project no.: 303445, FP7-JTI

Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - General SOC Testing Guidelines
Qingxi Fu (EIFER) / SOCTESQA - Project no.: 621245, FP7-JTI

Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - Start-up
Sune Veltze (DTU) / SOCTESQA - Project no.: 621245, FP7-JTI

Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - DELIVERABLE REPORT: List of SOC Test Procedures
T. Malkow (JRC) / SOCTESQA - Project no.: 621245, FP7-JTI

Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - DELIVERABLE REPORT: Test Matrix Document
Qingxi Fu (EIFER) / SOCTESQA - Project no.: 621245, FP7-JTI

SECTION 2: Other Sources

Accelerated lifetime testing and standardization of SOFC systems
M. Naslund, H. Iskov / Danish Gas Technology Centre

Degradation testing – quantification & interpretation
Johan Hjelm / International Workshop on Degradation Issues in Fuel Cells, 21-23.09.2011, Thessaloniki, Greece

Solid Oxide Cell and Stack Testing, Safety and Quality Assurance (SOCTESQA)
C. Auer еt al. / E C S Transactions, 68(1), 1897- 1905

The Status of Home-Installed SOFC System Development at Osaka Gas
S. Inoue et al. / Fuel Cell Development Dept., Osaka Gas Co., Ltd.

Anode degradation mechanisms in SOFCs
C. Argirusis / International Workshop on Degradation Issues in Fuel Cells, 21-23.09.2011, Thessaloniki, Greece

A Comparison of US and EU Test Protocols
I. Bloom et al. / Argonne National Laboratory

Spatiotemporal simulation of nickel oxide and carbon phases formation in solid oxide fuel cells (SOFC)
J. P. Neidhardt et al. / German Aerospace Centre (DLR), Institute of Technical Thermodynamics

Degradation and Durability of SOFC Materials by the Impurities
T. Horita еt al. / Fuel Cell Materials Group, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, JAPAN

Mechanical properties and electrochemical durability of solid oxide fuel cells
Ke An / Virginia Polytechnic Institute and State University

Durability of anode supported Solid Oxides Fuel Cells (SOFC) under direct dry-reforming of methane
А. Lanzini et al. / Chemical Engineering Journal 220 (2013)254-263

Analysis of Percent On-Cell Reformation of Methane in SOFC Stacks: Thermal, Electrical, and Stress Analysis
K. P. Recknagle et al. /Pacific Northwest National Laboratory

CHAPTER 3: ENDURANCE Procedures and Protocols

 

DOWNLOAD the entire handbook.

Google+